It is definitely important not really to unplug the module until the red LED provides been off for even more than 5 secs. Once the process completes the module must become unplugged, plugged back again in, and fresh firmware composed to it. Once the driver installation is definitely full, you can unplug the component and put it back in to reset it, but this can be not required.Ĭlicking Upgrade Module Bootloader will change the MULTI firmwaré with an application which will revise the bootloader. This is usually to assure that the DFU-mode drivers are set up or upgraded correctly - if an old driver is existing it cannot become up to date if the component is not really connected. Flash Usb Repair V2 9 1 1 Drivers Are Set If the module is connected in, it will become reset to DFU mode during the motorist installation. Once erased, new firmware will need to become written to the module. Flash Usb Repair V2 9 1 1 Drivers Are Setįor an STM32 module the firmware and EEPROM information are usually in the exact same file.
